
Supporting Service
Gage Calibration
Request a quotation for gage crib calibration.
Request a quotation
StandardISO/IEC 17025:2017CoverageMissouri and the Greater Midwest
One Recall Schedule, Not Three
A CMM rarely sits alone in an inspection department. Calipers, micrometers, height and bore gages, indicators, gage blocks, and plug, ring and thread gages typically calibrate on the same interval cycle as the CMM itself.
Consolidating the gage crib with the CMM calibration schedule reduces the number of separate due dates a quality department has to track.

What Gets Covered
Items are split on the quote and certificate between accredited and non-accredited scope so a buyer can see which tolerances carry a reported uncertainty.
- 01
Hand tools
Calipers, micrometers, height gages, bore gages and indicators.
- 02
Fixed gages
Gage blocks, plug gages, ring gages, thread gages and pin gages.
- 03
Surface references
Surface plates and granite squares, checked for flatness and parallelism.
- 04
Recall management
Due dates are tracked against a single asset list covering the CMM and the gage crib.
How a Crib Is Scheduled
- 01
Inventory
Each gage is identified and logged against its own interval and tolerance class.
- 02
Scope check
Items are matched against accredited scope ranges before routing.
- 03
Calibration
Accredited and non-accredited items are calibrated and certified separately.
- 04
Recall
Due-date notices are issued ahead of the next interval.

Why St. Louis CMM Calibration and Repair
- 01
Accredited scope clearly marked
Quotes and certificates identify which items fall inside accredited scope.
- 02
One asset list
CMM and gage crib recall dates are tracked together, not on separate spreadsheets.
- 03
Granite and ring gauges included
Surface plates and granite squares are calibrated alongside hand tools.
Coverage across Missouri and the Greater Midwest
On-site service is scheduled across the metros and surrounding towns listed on this site. Machines outside that radius may still be served; ship-in arrangements are quoted on request.
Discuss Gage Calibration Requirements
List the gage families and counts for a crib quotation.